Additonal Techniques for Bubble Squeezes

[Stephen Richard]

An additional technique for complex layups with things in between the upper and lower layers is to place little chips of glass (Also called  chads) very near the edge of the piece.  this supports the glass a little longer and gives a better channel for air to escape.  It does often leave a mark, so needs to be incorporated into the design.

 You can also combine the "flip and fire" technique where you assemble the piece in negative on the base of the kiln, then put the base on top of the design elements.  Take the whole to rounded tack or full fuse.  Turn the piece over, clean it up, place the top over and fire.

[Becki]

 You can also combine the "flip and fire" technique where you assemble the piece in negative on the base of the kiln, then put the base on top of the design elements.  Take the whole to rounded tack or full fuse.  Turn the piece over, clean it up, place the top over and fire.

This is a technique I use often...probably more often than an actual bubble squeeze.